| Customization: | Available |
|---|---|
| After-sales Service: | 1 Year |
| Warranty: | 1 Year |
Suppliers with verified business licenses
Audited Supplier Audited by an independent third-party inspection agency
The machine structure and design principle:
1)Double column linear bearing guided, servo motor + synchronous belt drive lifting and lowering, can arbitrarily set the test height, and accurate positioning;
2) Touch screen + high response PLC control, faster response speed, more stable operation, can measure the acceleration, maximum landing end speed, test time and other data;
3)Aluminium peripheral frame is equipped with safety light curtain, which provides a more reliable guarantee for the safety of the operator;
4) Clamping fixture, cylinder falling speed, to ensure accuracy, can complete the 0-±180 degrees prismatic, angular, surface fall;
5)A variety of materials are available for the falling board to meet the needs of different users;
6) With height compensation function: the height of the fall is the height difference between the bottom surface of the mobile phone from the floor, fall front, side, bottom and top surface, only need to enter the length of the phone × width × height value, when choosing different fall surface and angle, the device will automatically calculate and compensate for the height difference between different surfaces required (adsorption of mobile phones in the middle of the position of the benchmark, in the centre of the sucker position to do a good job in reference to the mark, to prevent the phone when the phone the centre of the mobile phone is perpendicular to the diagonal of the suction cup)
7) The system can automatically calculate the friction attenuation of the guide bar and correct the height of the fall to ensure the speed of the end of the fall.
1. Site temperature: 5ºC~+28ºC (average temperature in 24 hours≤28ºC);
2. Relative humidity: ≤85%RH;
3. Power supply conditions: single-phase three-wire;
4. Voltage range: AC220V;
5. Allowable frequency fluctuation range: (50±0.5)Hz;
6. Protective earth grounding resistance is less than 4Ω;
7. Require the user to configure the corresponding capacity of air or power switch for the equipment at the installation site, and this switch must be independent for the use of this equipment.
1.Directional drop test
2.Free fall test
3.Automatic and manual function
4. Base height compensation function
5. Drop height, speed at the end of the fall, the number of tests can be set
6. Delayed release and sensor detection release selection function
7. Data calculation function, automatic calculation of acceleration, the end of the landing speed, test time, etc.
8. Can be connected to the mainstream brands of high-speed cameras, synchronous control, video editing, partition preservation and other functions (optional)
9. Pneumatic decoupling, even and stable force.
10. Safety protection function (operator limbs into the equipment inside, the equipment does not start, to protect the safety of the operator)
1.Test sample specification: size 100*100mm, weight less than 5000g
2.Test sample type: charger, battery, work model and other irregular products
3. Drop height: can be set within the range of 300-2000mm, displacement accuracy of +0.5mm
4.Drop angle:0-±180°
5.Test fixture: clamping type
6. Relevant standards: products based on the relevant enterprise testing standards
7. Drop surface material: A3 steel plate, wood (350x350x17mm), marble plate (350x350x18mm)
8. Test data: drop height, acceleration, end speed, test time, test times, etc.
9.Measured acceleration:>9.3M/S2
10.Time gain setting range:0.01-1s
11.Control mode: height + directional, end speed + directional, height + free
12.Drive mode:servo motor+synchronous toothed belt!
13. Control mode: touch screen + PLC
14. Air source: not less than 0.6MPa clean compressed air (customer's own)
15.Power supply: AC220V+10% 50HZ
16. Equipment power: 500W
){kind=link}